RCS has remade the pancake holster
with our new, nearly unbreakable Pancake Wings. These loops replace your
standard belt loops on the holster shell turning it into a close, low
profile pancake-style holster.
As always, you have options. You can
now select your belt size for a more perfect fit. We have added an
"offset" bend in the loops. This allows for a tight, tighter, and
tightest fit depending on how you mount the wings. You can mount them to
the inside face of the holster with the logo facing outward for the
tight fit. This allows the easiest belt threading and gives you more
room to seat the grip. Swap the wings front to back and mount with the
logo facing inward to give you an even closer pull to your side.
Finally, you can mount the wings on the outside face of the holster with
the logo facing outward. This will lever the holster even tighter into
your side. You can also try mounting the wing higher or lower to adjust
the cant angle or even mount them upside down to play with different
fore/aft cant and fit options.
We encourage you to "play" with these
to find the sweet spot of comfort and concealment. The only rules to
follow as you experiment is that the posts should always seat against
the pancake and the screws should always seat against the brass eyelet
of the holster. The rubber o-ring should always sandwich between the
wings and the holster.
As always, we recommend that once you
find a configuration you like, apply some non-permanent thread locking
product to the screws to prevent them from backing out during use and
check your gear regularly.
Sold in pairs.
Image shows mounting hardware installed on holster, holster/gun not included.